RC Tank Warfare community hobby forum

hey does anybody know as the question says if a HL with el-mod setup will run with a stugg re-coil

cheers,

Matt

it should do as the fire button sets the recoil off
regards,ice

Matdragon wrote: hey does anybody know as the question says if a HL with el-mod setup will run with a stugg re-coil

cheers,

Matt

Sure it will fire is fire, and once you signal to fire it will work! I am using the DBCRC2 with the Stug and I still get recoil everything!

The Blitz

thanks guys, just wiring in a tamiya re-coil seems a bit complicated

cheers.

Matt

Matdragon wrote: thanks guys, just wiring in a tamiya re-coil seems a bit complicated

cheers.

Matt

Matdragon wrote: thanks guys, just wiring in a tamiya re-coil seems a bit complicated

cheers.

Matt

Matt,

Remember the picture is showing you the bottom of the 8 pin socket connector that is usually screwed to the top of the tank hull! Your Blue wire with the diodes attached can go to any ground or if you have power bar ground, it can go there! The other two wires must have the resistor linked between them and then just solder them to the back of that connector to the corrisponding line! Also remove the jumper from the TLS! The mechanical part of it was hard for me, I thnk the new mechanism is the way to go in the future!

het thanks blitz, but what new mechanism

Matdragon wrote: het thanks blitz, but what new mechanism

The new heng long recoil unit!

oh, right, sorry i thought you were talkin about something else new again LOL

You know i can't talk about the new stuff yet!!!

oh right, so their is new, new stuff... well... err, you know we are your friends... we wont tell ....