RC Tank Warfare community hobby forum

Hi,

In step 3 of Tamiya Panther build where the tension pulley are attached i'm having problems getting MA4 bolt screwed right down to the bottom of screw MD1. MA4 wont go furher than a few turns on MD1 yet this needs to go right to the bottom of the screw MD1.

I have built a tiger 1 and uses same mechanism but can't recal having problems(it was 3 years ago though !).

Has anyone had simular probs?

Cheers
Simon

Hi

Finally sorted this by locking the bolt with plyers and then screwing in from underside of tank.

Cheers