Page 1 of 1

help with wiring led guns to the henlong tanks

Posted: Thu Oct 07, 2010 11:21 pm
by stargate
hi all
is there any one out there that can help me wire up my led guns to my tank as i have a panzer iv and it has the rx18 in it so can any one please help me ?????? many thanks from john

Re: help with wiring led guns to the henlong tanks

Posted: Fri Oct 08, 2010 12:25 am
by Saxondog
Sure John I can help, the attached drawing should describe what you need to do, if their is still a problem we can work through it , cheers Saxondog (Blake)
8 Pin connector Detailed.jpg
8 Pin connector Detailed.jpg (91.34 KiB) Viewed 1062 times
8-PLUG WIRING SCHEM..jpg
8-PLUG WIRING SCHEM..jpg (49.29 KiB) Viewed 1062 times

Re: help with wiring led guns to the henlong tanks

Posted: Fri Oct 08, 2010 1:11 am
by stargate
hi ,i am still lost ...the guns i have got are fron welsh dragon models i hope that helps any body thay have a red and blue wires..if there is a diagram showing me where to put them it would be most help full as i dont have a glue in wiring ....thanks for the help......

Re: help with wiring led guns to the henlong tanks

Posted: Fri Oct 08, 2010 1:37 am
by Saxondog
Ok, here is what to do, first of all you will need to open the Tank, have you done this? First step so I will stay online and we can work this out. So answer the question, then we may need to go too chat to do this mod. Blake

Re: help with wiring led guns to the henlong tanks

Posted: Fri Oct 08, 2010 10:42 pm
by xrad
Great Pics Sax!

Re: help with wiring led guns to the henlong tanks

Posted: Fri Oct 08, 2010 11:27 pm
by Saxondog
Thanks Xrad, they really do help simplify the control system. But i'm afraid the simple MG install may be a bigger job than realized. But this is the right place for advice.

cheers Sax

Re: help with wiring led guns to the henlong tanks

Posted: Sat Oct 09, 2010 11:36 pm
by stargate
hi saxondog
i have done it now i had to change the leds as the wons that came with the guns thay did not work,but when i looked at your info thay work .so thanks for the help

Re: help with wiring led guns to the henlong tanks

Posted: Sun Oct 10, 2010 3:34 am
by Johnf
Hi,
If the LED is red try changing to white. I changed my red mg LEDs to the heng long headlamp LEDs which are too bright and fitted some yellow LEDs to the headlamps. Looks much better.