Hi, I don't know if any body has had this problem with thier Mato Sherman but while we was I/R battleing on grass the teeth come off the pins what go across the tracks, so I have centre dotted all the the pins both sides of the tracks and doing a test run every thing seems fine up to yet, I tried to rivet the ends on a few but they are just not long enough. I think its quite a good tank now I have RX18 in I/R and barrel recoil. Just got to spray it sometime.
Bob
track teeth
-
tanker bob
- Recruit
- Posts: 8
- Joined: Sun Oct 05, 2008 3:51 pm
- Location: Boston, Lincolnshire.
-
mcevoyi
- 2nd Lieutenant
- Posts: 2295
- Joined: Fri Sep 26, 2008 11:24 pm
- Location: Now Living in Cyprus .... Modellers desart ...
Re: track teeth
hi there bob
thats for thee heads up .. will dot my tracks when i get them !
iain
thats for thee heads up .. will dot my tracks when i get them !
iain
-
X82d Pathfinder
- Corporal
- Posts: 364
- Joined: Tue May 24, 2011 3:43 am
- Location: Colleyville, TX.
Re: track teeth
Bob:
Are you talking about using a center punch to spread the end of the pin in the track guards? Did you do both sides of the track if so? Do you have the stock plastic chevron, or did you do this to the metal cleat tracks?
-Dan
Are you talking about using a center punch to spread the end of the pin in the track guards? Did you do both sides of the track if so? Do you have the stock plastic chevron, or did you do this to the metal cleat tracks?
-Dan
A Commander has to make vital decision on incomplete information in a matter of seconds, and afterwards the experts can sit down at leisure, with all the facts before them, and argue about what he might, could or should have done.- Sir William Slim
