RC Tank Warfare community hobby forum

Since converting the 'boxes to 3 to 1 the Tiger has performed superbly
until the other Sunday when it threw the right track .

Upon examination,the only thing I could find was a lot of "float" in the RH box's
output shaft.
I haven't stripped it yet but I suspect it's the outer bearing come loose.

Can I fix it into place with epoxy resin(might as well do the LH while it's apart)?
Sure I read somewhere that epoxy wasn't ideal?

Cheers,Mark

Hi Mark I've used superglue to fix my HL Gearbox bearings in place. Also seen them soldered in as well. Hope this helps
Alan

I superglued 'em in to start with Alan.
Superglue(or cyano for our U.S readers)tends to be strong but brittle.
I either didn't use enough glue or the stuff I've used(supposed to be industrial)
isn't strong enough,that's why I wondered about epoxy.

Mark