RC Tank Warfare community hobby forum

hi all

got my hands on the older tam KT 56004

and will fit a 4 channel radio gear ...

but can any recomend some servo ??

iain

do you mean servo's for the gearboxes ? are you going to keep the orriginal dual clutch gearboxes ? you'd be best off switching them for some 3-1's

cheers,

Matt

Ive got the same Old 1970's KT. If its a clutch version you wont be able to use an RX18 or tammy control box.Ive got ACOMS in there and it works well but the main trouble is and CRISPY (will vouch for this) the engine in these eats batteries. Mine runs for around 10 minutes before the battery needs chopping out! Getting the clutch alinged Juuust right is a must and be careful where you spray the oil! The clutches can be finickity. If money allows think about ditching the oldgearboxes and put a dual box in

hi there rocket ..info taken on board ...

i will at some point chance the old gbox for a pair of new ones .. but just for now want to get it running so the info on the servos is most helpfull

thanks

iain

Matdragon wrote:do you mean servo's for the gearboxes ? are you going to keep the orriginal dual clutch gearboxes ? you'd be best off switching them for some 3-1's

cheers,

Matt

thanks matt ... will change out the gearboxs at some point .. but just want to get it running first

iain

Does the old girl contain the Turret turn motors? bit of a weird set up. When you turned the tank teh turret turned! I disconnected mine!

Got any pictures if teh gizzards?

K

it has like a nuttie motor with a wackie looking gear box sat in the hull which is atachet to the turret by a metal pole ....

will get a pic or two tomorw for you rocket

Ok, what should happen is that there is a rod, that comes from the clutch servo arm. It's attached to a small two way circuit breaker. When you steer the tank, it moves the servo which moves the arm which activates the awitch which send ppower to the motor into the turret turn mechanism.

Simple really