RC Tank Warfare community hobby forum

first i drilled out top of cupola as im not useing bbs then i took off turret back door cut off hinges then drilled holes in side of door & hinge i used paper clips for door & handles also filled in door with plastic sheet








chris

nice job so far, keep the post comming!
Ed

thanks ed i have stripped out the gearbox and electrics dremeled out screw studs put in plastic base now im not sure of the right position of gearboxs need a bit of help here



chris

I was going to upgrade my KT like you, but I decided to go with tamiya hull and suspension as there were more mods (motors, wheels, etc..)available. I will use HL electronics and Matorro upper hull....

i think your right to go the tamiya way but i will stick with it as i dont have funds to spend on it at the moment as i have 3 other tanks to do

chris

i have taken out plastic sheet and put in aluminium (thanks to tankman) much stronger then screwed in gearboxes i hope this works this is my first time doing this sort off work



chris

so far installed metal gearboxes rx-18, receiver and new speaker all working ok just have top hull to sort out





chris

Hi chris you have a pm

if your planning on having a smoker for the hassle involved id pop a new one in from h/long

Looking very good Chris. I think you will have yours ready before mine lol.
Alan