Panther G convoy light
Posted: Sat Dec 06, 2025 10:58 pm
Hi all
Progressing on fitting convoy lights to my German tanks it is now the Panthers turn
I had previously ordered a shop bought light which arrived yesterday its a nice light but pricey
After removing the molded original light i drilled a wee hole through the backpanel and glued new light in place
I extended the wires and spliced the convoy light into the wiring for the front light and incorporated the resistor it came with into the cct
The Panther is a Taigen model so MFU is different this time and no clear indication where to plug it in so spliced it was
Finished light
Progressing on fitting convoy lights to my German tanks it is now the Panthers turn
I had previously ordered a shop bought light which arrived yesterday its a nice light but pricey
- CV 9.png (555.4 KiB) Viewed 84 times
I extended the wires and spliced the convoy light into the wiring for the front light and incorporated the resistor it came with into the cct
The Panther is a Taigen model so MFU is different this time and no clear indication where to plug it in so spliced it was
Finished light
- CV 10.png (705.14 KiB) Viewed 84 times
Hello, attached is a wiring diagram (for information) for older boards, HL, Taigen, Torro, etc., operating at 2.4GHz or similar frequencies like the RX18. Everything is controlled by the 8-pin connector; the wire colors are (normally) the same as the cable between the board and the upper chassis. 