type 16 tank

[springbox]

i started building this type 16 rc tank, this is my progress so far

20250826_075442.jpg (2.26 MiB) Viewed 1353 times

20250826_075516.jpg (2.34 MiB) Viewed 1353 times

[Stormbringer]

Looking good mate

[Herr Dr. Professor]

Nice work! I will be watching for more.

[Meter rat]

That is impressive. I, too will be following. But may be ask a moderator to move it to other modern?

[springbox]

Thanks so much, will continue to post progress. I Will ask it to be moved to modern

[springbox]

Hi
I have changed the unsightly grill i tried to make and had it 3d printed (photo 2), looks much better. i have also installed a cooling fan (photo1), i plan to install another 2.
i have also install a side panel door, with step. the door is held closed with a magnet(photo3)

photo1.jpg (55.62 KiB) Viewed 784 times

photo 2.jpg (337.32 KiB) Viewed 784 times

photo3.jpg (129.79 KiB) Viewed 784 times

[springbox]

since my last post ive purchased a 3D printer and have made a few changes

new diffs.jpg (1.5 MiB) Viewed 319 times

diffnew.jpg (1.9 MiB) Viewed 319 times

[Gbo]

That looks very nice. Is this scratch built?

[springbox]

thanks, yes its a scratch build

[springbox]

a few more changes

made a holder for receiver

receiver.jpg (395.84 KiB) Viewed 247 times

used a switch to operate a relay

relay.jpg (671.56 KiB) Viewed 247 times

holder for smoker

smoker.jpg (385.15 KiB) Viewed 247 times

smoker working

smoke.jpg (492.86 KiB) Viewed 247 times