RC Tank Warfare community hobby forum

Hi. I have a HL v7 Panther.. I recently watched a video where they had fitted a bearing set up on their idler wheel and drive sprocket wheels. This was to reduce the loading on the axles.

Is this a part that I can buy and fit or was this a custom job..

Many thanks

Hi, you can get them at rctank.de

https://www.rctank.de/Jagdpanther-Panth ... ngs-799-mm

Just make sure you get the right diameter. I think these are the right ones however they come in three different sizes. Email then and theyll help you get the right ones. Dominique is very helpful.

They are an excellent addition, will stop wear on your gearboxes, highly recommend them.

Cheers

Dave

Sent from my SM-S938B using Tapatalk

Is your panther a pantiger if so that has tiger 1 lower hull and running gear not panther two different tanks

The version you have is a Tiger lower hull.
Tigers are fickle for throwing tracks too .

Spotted these Henglong Metal Drive Axle Bearings For German Tiger I Tank I RC 6.0 7.0 1/16 3818

Will this fit my Pan Tiger?

the pan tiger is basically a tiger 1 bottom with a diferent deck on top so if they are for a Tiger 1 they should fit

Many thanks