RC Tank Warfare community hobby forum

Hi all, just started looking into potentially 3D printing my first RC tank! Looking to go with a Cruiser MK VI or a MKVIII and thought a good place to start would be to join these forums for references and help!
I'm expecting it to be quite a project and to take a while to complete, but looking forward to the challenge.

Woo Hoo! You sure found the right place here! There are 3D printing wizards galore--as you likely have already seen. Your questions and certainly a progress report (with photos ) will likely get you lots of help and supportive responses.

Welcome from Ontario, Canada!
I will be following! Where are you thinking of getting your files from? That will be a cool project!

Mike.

Thanks for the welcome!
I've been looking at warprints.xyz for the STL files for the Cromwell. Seems pretty comprehensive.
I'm now looking for wiring diagrams and what I would need in terms of transmitter/receiver etc.

Hello and welcome to the forum Troez

Have you checked out the first post list in this thread?
.
viewtopic.php?t=32236