RC Tank Warfare community hobby forum

Hi All

        Once again I need your assistance/advice

I have purchased a set of Modellbau track tension adjustors for my H L Tiger 1.

To fit this I need to remove the plastic idler mount (the part the original screw goes into).

Has any one removed this part before, is it glued on or is it moulded?

My guess is that it is glued on and hopefully a sharp knife in the right place and it will come off


Once again many thanks for all forthcoming advice


                                                                  Jim

Hi Jim,

Moulded, you ned a "razorsaw" (I am not sure if this is the correct name, check pic #3)



Regards

Jake

Many Thanks Jake