Page 1 of 1

Next project on the way

Posted: Tue Mar 19, 2024 5:37 am
by Sam84
Hello again,

To everyone on the forum all of the builds that everyone does inspires me and gives me ideas on what to do, I thank each and everyone of you guys. Keep up the good work everyone.

I have started my next two projects the sdkfz 251 which I got off if cults 3d and my Panzer iii of the 24th Panzer division the leaping horsemen of Stalingrad.

Will post more pics as I do both of them, if have any ideas or corrections on these both please let me know and I will try and do my best to fix them :D .

Again keep up the good work everyone :D .
IMG_20240318_184810497~2.jpg
IMG_20240318_184810497~2.jpg (1.26 MiB) Viewed 655 times
Many thanks

Sam
IMG_20240318_184817515~2.jpg
IMG_20240318_184817515~2.jpg (2.11 MiB) Viewed 655 times
IMG_20240318_184835728~2.jpg
IMG_20240318_184835728~2.jpg (1.24 MiB) Viewed 655 times
IMG_20240318_184842214~2.jpg
IMG_20240318_184842214~2.jpg (1.25 MiB) Viewed 655 times
IMG_20240318_184848797~3.jpg
IMG_20240318_184848797~3.jpg (2.1 MiB) Viewed 655 times
IMG_20240318_184858547~2.jpg
IMG_20240318_184858547~2.jpg (730.47 KiB) Viewed 655 times

Re: Next project on the eay

Posted: Tue Mar 19, 2024 9:09 am
by Meter rat
Following along with this. Two interesting looking vehicles.

Re: Next project on the eay

Posted: Tue Mar 19, 2024 2:25 pm
by Martin2556
Hi Sam, I will be following your new projects, you may find my Panzer III build of interest, link below:

viewtopic.php?t=30246

Re: Next project on the way

Posted: Tue Mar 19, 2024 3:34 pm
by Herr Dr. Professor
I'll be watching, learning, and cheering for you, Sam84.

Re: Next project on the way

Posted: Mon Apr 01, 2024 7:39 pm
by Sam84
Hello everyone,

Well the Panzer iii is almost complete just waiting on some decals and a speaker and some rust paint from Oz armour should be here by end of the week.

Martin 2556 your Panzer iii looks great you did a very good job on her :D .

I'm going to be running the second ibu2 board through her, just got a few kinks to work out will try and upload a short vid of her running :D .

I used a mix of printed parts and original parts cut off of it, the track cable is hanging wire with a bit of mig wire hand piece gut cut. Printed the exhaust system and made work from the heat unit.
Use clear plastic in the commanders hatch, and drivers visor.


Started on the crew and doing a bit more to the APC.

Without further ado here she is.

Re: Next project on the way

Posted: Mon Apr 01, 2024 7:48 pm
by Martin2556
Your Panzer III is looking great, well done 😊

Re: Next project on the way

Posted: Tue Apr 02, 2024 12:57 am
by Herr Dr. Professor
:eh: I had never thought of using clear plastic for the visors. As my mother used to say about the obvious that never occurred to me "...been a snake, it woulda bit ya!"