RC Tank Warfare community hobby forum

I have an i6s that is only about 3 months old.
when it arrived I was able to get into the settings via the touch screen and set up the channels for the clark board and pair the RX.
I have now found that I need to reverse the throttle channel.
However I cannot access the TX via the touch screen.
nothing happens when I touch the lock button.

Is it now a brick or is there a work around

many thanks for your help

I've had this happen on a couple of mine, some times it's the cable.for the screen isnt seated right if it's been dropped. On my other happened for no reason I could see and is only useful for what ever model it's been bound too

Are you holding the lock button for like few seconds? There is a setting that sets how long the lock button needs to be pressed before it releases.

thanks for replies,
Yes holding for quite some time and no response

will have check on the cables