Today I worked on the trackguards.
I used Aber photoetch dot pattern antislip plate. The size is about perfect.
- hummel30.jpg (1.52 MiB) Viewed 5733 times
Once again, more time behind the computer and in front of the CNC than assembling the parts !
- hummel31.jpg (894.98 KiB) Viewed 5733 times
The parts, this time I reproduced the frame (a bit simplifier) of the 1:1 Hummel unlike what I did on my first model. This way I can glue the PE from the underside ! And it's easier to remove if I glue it the wrong way (learnt it the hard way on my first model, totally screwed the PE when I tried to debond it
). So here are the parts :
- hummel32.jpg (1.6 MiB) Viewed 5733 times
Assembling the parts :
- hummel33.jpg (1.75 MiB) Viewed 5733 times
Gluing the PE, on the 1:1 Hummel, each trackguard is made of 2 pieces, the curved one and the flat one. Unfortunatly the Aber PE was not long enough to get the flat section in one piece.
- hummel34.jpg (1.22 MiB) Viewed 5733 times
- hummel35.jpg (1.53 MiB) Viewed 5733 times
In place :
- hummel36.jpg (868.69 KiB) Viewed 5733 times
- hummel37.jpg (901.94 KiB) Viewed 5733 times
- hummel38.jpg (900.42 KiB) Viewed 5733 times