MG2
-
- Recruit
- Posts: 21
- Joined: Sun Mar 05, 2023 5:39 pm
MG2
Clark tk board CH4 is wired to a led. Was hoping that pressing the MG2 button I hear a gun shot but no flashing led. From CH4 the led just stays permanently on like a light basically. Do I need to change Sony remote settings to fix this issue?
-
- Warrant Officer 1st Class
- Posts: 1665
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: MG2
Good evening, Ch 4 is the channel 4 input of the receiver? if I understand your explanation correctly? there cannot therefore be a Led MG connected directly? or did I misunderstand? ? what type of card do you have? TK 24/40/50/80 ...
what type of transmitter do you have? standard or bus system?
what type of transmitter do you have? standard or bus system?
-
- Recruit
- Posts: 21
- Joined: Sun Mar 05, 2023 5:39 pm
Re: MG2
Yes I have the sbus system. I can fire both machine gun sounds. However CH4 a red light lights up permanently instead of flashing with the machine gun sound / button. Is there anything on the Sony remote I need to press to enable the CH4 function as an LED flash?
-
- Warrant Officer 1st Class
- Posts: 1665
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: MG2
Hello ,
I don't know if can help? but here is what our friend "Tank me" had posted some time ago!!!
viewtopic.php?t=32375
Also ask the question in PM to a specialized member "Clark" on this forum, Maxmeker
I don't know if can help? but here is what our friend "Tank me" had posted some time ago!!!
viewtopic.php?t=32375
Also ask the question in PM to a specialized member "Clark" on this forum, Maxmeker
- tankme
- Warrant Officer 1st Class
- Posts: 2004
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: MG2
I'm a bit confused also after looking through Clark's docs. My educated guess is that CH4 MG2 function is for the non-Sbus type boards and the CH4 is triggered with stick movements. For the Sbus boards, VR A triggers the MG2 LED connection wired to pins 3 and 4 on connector CN9. In order to make that work you need to select option 8 (Power button on remote). This is a just an educated guess at this point since I've never hooked up an MG2 on a newer Clark. Hopefully this helps.
Derek
Too many project builds to list...
Too many project builds to list...
-
- Warrant Officer 1st Class
- Posts: 1665
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: MG2
Hence my question? what kind of plate? if I rely on the latest info from Tank me, the MG 2 led is connected to CN 9 and therefore would work from an inter or knob? so direct on Ch.4, knowing that there is only plus and minus and command signal, would explain why the Led is permanently lit?Sherman1981 wrote: ↑Sat Aug 26, 2023 4:41 pm Yes I have the sbus system. I can fire both machine gun sounds. However CH4 a red light lights up permanently instead of flashing with the machine gun sound / button. Is there anything on the Sony remote I need to press to enable the CH4 function as an LED flash?
if it is possible to use certain outputs Ch.? I do not understand well (but possible) how one activates the functions starting from the transmitter? since as said before, there is only permanent 5 volts, and control signal?