Page 1 of 1
1/12th Scale Stug...
Posted: Tue Jul 26, 2022 3:34 am
by Spinnetti
Well, with the Hetzer Pretty well done (except cammo and a few acessories), I've decided to start the next one, the Stug III. Not in a huge hurry, but will peck away at it. As usual, I start with a known dimension - the tires, and scale everything off that. As usual, with every part I make, I go back and tweak/refine what's gone before, so this is a first draft of the road wheel assembly. No doubt it will get plenty of tweaks before I'm done.
Re: 1/12th Scale Stug...
Posted: Wed Jul 27, 2022 3:48 am
by c.rainford73
What type and size printer does it require to make such large prices of armor?
Re: 1/12th Scale Stug...
Posted: Wed Jul 27, 2022 3:19 pm
by Spinnetti
c.rainford73 wrote:What type and size printer does it require to make such large prices of armor?
Ha! Well, you can break it up in however many pieces are needed to fit. I use a PRUSA for most stuff, a Mars and/or Saturn for the higher detail stuff, and a Chiron for the hull and superstructure, which for the Hetzer prints in a single piece (16" or so bed)
Re: 1/12th Scale Stug...
Posted: Wed Jul 27, 2022 6:31 pm
by RiskyR
Oh yes! I'm definitely going to follow this one. Looking forward to see your designs and thoughts on this tank.