RC Tank Warfare community hobby forum

This build is for the m4 105, it will become a Canadian support tank when I can find the markings

There are a few photos to accompany this, showing the printed parts and how I plan on the stowage to be.

Unfortunately the photos were taken in landscape therefore are sideways

Yet to be added are the engine doors metal suspension wheels and tracks

Build threads like this inspire me to get a second tank. Looking good so far

I thought I was the only one who used the wrong mode with my phone camera!?!

EB, that is some very nice work! You guys have a knack for making things look sooo easy!

Cheers,
Eric.

Nope I can’t work a camera either. Not done anything to it since I uploaded those photos of the 3D work other than prime the top half and though it’s yellow it looks much better. I will bung a photo up when I learn how to use the camera

As I am now in the final stages of setting up my own printer I should soon be able to offer my 3D parts to the forum. I have engine decks for the a1 a4 a2 and as seen here m4, also I have the pepper pots and m4/m4a1 exhaust defuser, late small hatches, early direct vision hatches (fully functioning still in development. Extractor fans and fuel/water caps. Also in development are a2 exhausts and early bogies for m3, m4a1/a2

Some have these designs I have had for sometime but never been able to sell because forum rules dictate items must be designed and printed on your own printer and I just used to send the design to my dad to print on his.

So after this post I ask our team of moderators to check that the above is with in the rules before I put up any photos on an independent thread of my available parts and advise me on the decision