RC Tank Warfare community hobby forum

Hi all, After a recent flurry of parts from FORGEBEAR tanks I have made a start on this Jagdpanther
which will go into the semi completed tank abyss.

Mato gearboxes were fitted which run superbly, I recently fitted a set into a Taigen Tiger 1 which was a easy
job, not so easy here though.

Nice shiny black new base

Home brewed servo recoil and elevation.

One thing I have found on many builds is when fitting metal taigen sprockets on to these Mato gear shafts
or the DKLM gear shafts is the sprocket is a loose fit, by fitting heat shrink on the gear shafts it gives a
snug fit.

Ludwig von wigbearer wrote:One thing I have found on many builds is when fitting metal taigen sprockets on to these Mato gear shafts
or the DKLM gear shafts is the sprocket is a loose fit, by fitting heat shrink on the gear shafts it gives a
snug fit.

A useful tip, Ludo!. The upgrade is progressing well