RC Tank Warfare community hobby forum

Hello,
yesterday and today some brass formed, machined and soldered... plus 3D-printed etc.
There are already some controls for the driver:
The exhaust silencer attached:
Fuel filter pressure control unit and main cock made:
Steering wheel with holder, indicator switch console and adjusting lever unit printed and attached:
That was a little progress report.
See you soon...and thanks for looking.

absolutely fantastic work!

Fantastisch.

Hello,
next small update...
Yesterday afternoon I made the gearstick lever and the handbrake lever:
That's it again.
See you soon...and thanks for looking.

Today I have done a bit more.
I attached the eyelets for the cab tarpaulin and the front wall of the loading area.
Then I played around a bit with the 3.7 flak and added accessories to see where what fits best...
See you...and thanks for looking.

Hi Mr Jhamm,
Nice to see another halftrack build, itching to try mine out now after seeing yours run, i take it its a diy control board ?
Arduino based maybe ?.
Most excellent.
Kind regards Sub.

Sub wrote:Hi Mr Jhamm,
Nice to see another halftrack build, itching to try mine out now after seeing yours run, i take it its a diy control board ?
Arduino based maybe ?.
Most excellent.
Kind regards Sub.

Hey Sub,
it is a SGS Halftruck Controlboard:
https://www.sgs-electronic.de/webshop/p ... -s-32ls-ht

Regards
Jürgen

Great subject and excellent build !

Superbly done, refined and unique. You are doing an inspiring model.

I assume it is the Vandra Flak 43.

Hello,
step by step...
Base colour Dunkelgelb is applied:
The frames for the side flaps of the loading area are made with a soldering iron and brass profile:
The flak in transport position:
thanks for looking