Job lot of Arduino/IR/Sound components etc
Posted: Thu Aug 12, 2021 11:48 am
Having a clear out.
Ok, there is a lot here, electronics guys will know what they are looking at, but I will try and cover most of it. All components are sold 'as seen', even though many of them are new and never used. They have been sat in a cupboard for years.
Arduino clone boards x 4. I haven't a clue whether these are working.
Arduino 2560 board. Should be working. It's a genuine board not a clone.
10 amp speed controllers (might be 20 amp - I can't remember).
RC signal converters, SBUS etc, one definitely works, not sure about the other one.
Loads of pin connector wiring.
Benedini clone sound boards, one large, one small.
Programming USB for sound board, needs one 3 pin wire fixing.
Various mini speakers.
PAM amplifier boards.
Bluetooth boards.
IR Emitter and Receiver boards.
Movement sensor.
Pin Strips.
Arduino 2560 screw connector strips.
SD Card Reader
Various other bits and pieces.
2 Axis gyro.
Various switches.
2 microswitches.
Please note that this is being sold as one job lot, and that I am not offering to provide any back up, advice, or assistance on how any of these items are used.
Payment by Paypal.
£30 + £5 postage. UK Only.
Ok, there is a lot here, electronics guys will know what they are looking at, but I will try and cover most of it. All components are sold 'as seen', even though many of them are new and never used. They have been sat in a cupboard for years.
Arduino clone boards x 4. I haven't a clue whether these are working.
Arduino 2560 board. Should be working. It's a genuine board not a clone.
10 amp speed controllers (might be 20 amp - I can't remember).
RC signal converters, SBUS etc, one definitely works, not sure about the other one.
Loads of pin connector wiring.
Benedini clone sound boards, one large, one small.
Programming USB for sound board, needs one 3 pin wire fixing.
Various mini speakers.
PAM amplifier boards.
Bluetooth boards.
IR Emitter and Receiver boards.
Movement sensor.
Pin Strips.
Arduino 2560 screw connector strips.
SD Card Reader
Various other bits and pieces.
2 Axis gyro.
Various switches.
2 microswitches.
Please note that this is being sold as one job lot, and that I am not offering to provide any back up, advice, or assistance on how any of these items are used.
Payment by Paypal.
£30 + £5 postage. UK Only.