Page 1 of 1
Taigen upper the henglong 6.0
Posted: Thu May 13, 2021 2:54 pm
by tomhugill
Has anyone hooked up a new taigen upper (with the high intensity led flash) to a Heng long V6 board?
My main points of query is where would the flash hook up and how does the recoil work? I'm assuming you can wire a two pin to the BB motor socket and use the BB switch to the recoil switch? Maybe? Any help greatly appreciated!
Sent from my SM-G973F using Tapatalk
Re: Taigen upper the henglong 6.0
Posted: Thu May 13, 2021 4:01 pm
by john1970
viewtopic.php?f=79&t=30524 for the recoil
for the flash you will need a single channel 5v relay
Re: Taigen upper the henglong 6.0
Posted: Fri May 14, 2021 12:31 pm
by tomhugill
Super John thank you.
Any more info on the flash?
Sent from my SM-G973F using Tapatalk
Re: Taigen upper the henglong 6.0
Posted: Fri May 14, 2021 9:18 pm
by john1970
This is what i done on the 6.1 board i haven't tried it on the 6.0 board yet. The wiring for the flash unit will be the same on the 6.0. There are a few option on powering the 5v relay on the 6.0 you can either copy whats been done on the 6.1 and split the wires from CN10 so it does both the recoil and 5v relay or for the signal you can use LED 1 negative. For the power either double up on CN2 or use CN5 but that is switched on/off via the controller.
There is also a few youtube videos of someone doing these not sure where they got it from
https://www.youtube.com/watch?v=M-UJdFHfapI
https://www.youtube.com/watch?v=TrCSPz-8qq8
john1970 wrote:
Basically the haya 6.3 is a rebranded heng long 6.1 so should be exactly the same.
What you will need is a single channel 5V relay.
loop the microswitch cn6 a shorter wire would be better
The xenon flash has 3 wires red positive + , blue negative - and black positive signal. Remove the 3 pins from the plug they are in and put the red and blue wire into a 2 pin plug and plug into cn2 red on the left.
The black wire will go into com on the 5v relay i'm using a dual channel relays as i cant find my single 1
To provide the power for the positive signal take a wire from led 1 + and plug into NO on the 5v relay
To power and provide signal for the 5V relay you can use cn10 as the bb gun is no longer in use and is activated when you fire the gun .The negative wire will need to be looped to the ground and signal on the 5V relay and the positive will go to positive on the relay
So when you fire the cannon cn10 will activate the relay which will connect COM with NO sending a positive signal to the xenon flash