RC Tank Warfare community hobby forum

Hello i think i just ruined my controller board its a Taigen V3 2.4 GHz PCB board plugged in a 2cell lipo and it worked for a while then it lost controll and i turned it off. now only the fan spinns nothing else works.

what do you think do i need a new board?

Hello,
i think we need an introduction of you, as recommend by the first Mail after registration.

hello, unless I'm mistaken? you forgot to go, by the box presentation ?? if you want an answer, it would be nice to do it, it's the minimum on a forum, to introduce yourself, before posting

Postby Nicklas.S » Sun May 09, 2021 4:13 pm
Hello My name is Nicklas Svensson Live i Sweden, long time RC guy everything from cars, helis, planes and now Tanks :)also dabble in some Archery aswell
2 kids 2 and 4 work at a retailstore,
Got myself an unpainted torro BB Leopard 2a6.

Welcome from Illinois. I will offer my opinion. Now is the perfect time to upgrade your control board and get a hobby grade radio. I consider it a good time to upgrade any components as the originals breakdown. A programmable radio and advanced control board will really increase your level of enjoyment. You have a lot of rc experience so I have no doubt you’ll want to upgrade as you go along. Just my humble opinion.

Hello, and welcome to this great forum, it didn't take a lot of time, and we know more about you and your passions
for your concern, i don't think that is an HS card problem? but more than the lipo is below the voltage needed to operate? but just enough for the fan, I personally would do tests with other batteries in Lipo or Nimh form

Jofaur86 wrote: Hello, and welcome to this great forum, it didn't take a lot of time, and we know more about you and your passions
for your concern, i don't think that is an HS card problem? but more than the lipo is below the voltage needed to operate? but just enough for the fan, I personally would do tests with other batteries in Lipo or Nimh form

I agree I think you need to either recharge or renew your battery, DO NOT rely on the charger that came with the Tank.

voltage is ok iam gonna try external reciver setup tomorrow (jumper T16 Hitec minima reciver)

ok, the voltage is correct (volts) at no load? but under load, with the motors? and the capacity (amps

found on the site RcTank.de and concerning the V3 board?
Cette platine n'est pas aligné pour les accus Lipo, Utilisation alors à vos propres risques et sans garantie