RC Tank Warfare community hobby forum

Hallo , I have this 10 channel IBU2U FO. I connected through the 360 slip ring wiring with no problem except that :
When i use SWA down to turn on the lights....the motors don't work, no sounds when using the left stick in other words the tank is "dead " just only hear the engine idle sound. Can anyone help me with that? Thank you very much

????? ?? SM-N950F ???????????? Tapatalk

Too less information for help.
I think there is a mismatch of the channels to the inputs of the IBU.

I bought it ready to install with radio

????? ?? SM-N950F ???????????? Tapatalk

The tank is Torro Leopard2a6 with muzzle flash and barrel recoil. Asiatam recoil system. 360°slip ring.

????? ?? SM-N950F ???????????? Tapatalk

Ready to install

????? ?? SM-N950F ???????????? Tapatalk

Mu supplier told me that it should be an IBU glitch and a Calibration would reset it. Are these numbers the Channels so to proceed at correct Calibration ??

????? ?? SM-N950F ???????????? Tapatalk

I did radio Calibration but nothing. Same problem. With or without tail lights ,with or without heng long plug for head lights, same problem .Had anyone same problem?

????? ?? SM-N950F ???????????? Tapatalk

Please look at the IBU Manual and check connections.
check output and channelorder of reciever with a servo too.

The first u said i did correct the connections
The second i don't understand how to do it

????? ?? SM-N950F ???????????? Tapatalk

leopardgreece wrote: The second i don't understand how to do it

Realy?