RC Tank Warfare community hobby forum

I am about to build a 1/16 sdkfz 251/7 based on the https://www.ludwigs-hobby-seite.de semi kit.

I want to electronically replicate the independent track braking on steering turns and I am trying to find a suitable controller.

Worst case I can do this with cut-out switches triggered by the steering servo, however I am hoping there might be a more elegant solution available.

Any thoughts would be appreciated.

Hello and welcome to the forum Mr Snowwolflair.

It would be very good if you could give us a little knowledge about yourself with regards to this hobby, it helps us help you, by knowing your skill levels for one.

Therefore may I suggest that you pop over to our introduction section as per request within your welcome private message

Thank you for the welcome.

In summary I have been building models for 50 years, I am an electronic engineer and I have a simple philosophy if I cannot buy it I design and make it.

Interests are R?C 1/16 tanks and 1/96 warships and N gauge trains which I design and 3d print.

I will drop a copy of this into introduction section.

Just awaiting front shields from Ludwig, detail painting, transfers and weathering.