RC Tank Warfare community hobby forum

I figured starting out as a new member in a new hobby. I started with just a bare hull and put it all together except the wiring schematic. I have a Pershing that has a 12 pin connector mounted on a board in the inside the top hull foreword along with 3-2 pin female receptacles and 1-3 pin receptacle. No manual or anything that would help in what wire goes where. The tank a 1:16 Pershing and I Carnot find anything that would help. The controller is a HL TK-6.1S and it has a receptacle that takes only 8 pin connector. Any idea where I might find said diagram or schematic.

Thanks in advance,
Bigmother62&

Hi
First of all, the 8-pin socket plate in the upper hull will not be needed anymore. Of course, if you can, you can build a new one for TK 6.1s. I recommend something like this if you have some soldiering skills:
viewtopic.php?f=79&t=30884

Secondly. Most mechanism and LED's requires 2 wires ( plus and minus ) and an appropriate plug. The description of which socket is for what you can found on the back of the metal housing of the TK 6.1s. And the wiring diagram for 6.0/6.1 (6.1s has the same wiring scheme as 6.1) in Google.

http://www.google.com/search?q=heng+lon ... 20&bih=525

eg. here:
http://rctank.pl/forum/viewtopic.php?f=76&t=2471