Page 1 of 1
Radiomaster tx16s.... how to change channel imput??
Posted: Sat Sep 19, 2020 7:28 am
by Andreabert
Hi guys
Sorry for the silly question.. but im a noob.
Got a tx16s with flisky receiver and new elmod.
All seem to be work except that
The stick up/down ( should ne throttle) is on channel 2
Ans left/right is on channl 1
How can i swap it.
I want that if i push the stick forward , the tank move forward... not left...
Thanks
Andy
Re: Radiomaster tx16s.... how to change channel imput??
Posted: Sat Sep 19, 2020 2:26 pm
by silversurfer1947
Swap the channel connections around on the receiver.
Re: Radiomaster tx16s.... how to change channel imput??
Posted: Sat Sep 19, 2020 3:00 pm
by Andreabert
i tryed . on the radio when i move the stick left or right i see the %... but the tank doent move
Re: Radiomaster tx16s.... how to change channel imput??
Posted: Sat Sep 19, 2020 3:38 pm
by Andreabert
anyone could assist me from the begin? im trying to create a model but i think i do something wrong
Re: Radiomaster tx16s.... how to change channel imput??
Posted: Sun Sep 20, 2020 6:47 pm
by silversurfer1947
Did you start the engine before trying to move the tank? If your board is anything like the one on my Puma, you have to start the engine by moving the throttle to maximum and holding it there for 3 seconds. Until then, the tank won't move. If you haven't already done so download the elmod instructuctions pdf. I found it very helpful.
Re: Radiomaster tx16s.... how to change channel imput??
Posted: Sun Sep 20, 2020 6:59 pm
by Andreabert
I solved the problem thanks. It was a mistake cabling the receiver