Tiger 1 how to wire cannon mantle MG
Posted: Tue Aug 04, 2020 3:13 am
Have a HL Tiger 1. It has all Taigen V2 electronics, daughter, mother board... transmitter, etc I have an Asiatam barrel recoil/flash which works beautifully ! I ended up purchasing two 'Asiatam' recoil units. One from Germany, one branded Taigen part from IMEX Taigen parts, FLA. Both same basically, although the German Aisatam unit is far more stout, battery, thicker wires, etc..
I installed a new improved LED machine gun from Forgebear, UK in the turret cannon mantle. How do you go about tying the wiring in with the daughter board. I'm thinking of using a JST 2 prong male/female connector ..one coming from the mantle MG, the other end not sure where to soldered it. Would like it to work independently of the hull MG gun.
Amy thoughts ?
I installed a new improved LED machine gun from Forgebear, UK in the turret cannon mantle. How do you go about tying the wiring in with the daughter board. I'm thinking of using a JST 2 prong male/female connector ..one coming from the mantle MG, the other end not sure where to soldered it. Would like it to work independently of the hull MG gun.
Amy thoughts ?