RC Tank Warfare community hobby forum

Hello All
Does anybody know of anyone who sells either resin or 3D printed rockets for a Sturmtiger?
Many thanks for any advice.
Cheers
Jonh

Hi,

we have here in Germany a dealer, here:

blank:
https://www.ebay.de/itm/Sturmtiger-Gran ... SwFb5bZZJH

with hull:
https://www.ebay.de/itm/Sturmtiger-Gran ... SwcZ9bZZKA

just the had:
https://www.ebay.de/itm/Sturmtiger-Gesc ... SwmINbZZKr

Greetz, Andy

I used only the had (from that same supplier, excellent stuff) to place in the barrel.

Thank you for the link.
Cheers
Jonh

I can also print them for you if you're in the UK?! =)
https://www.shapeways.com/shops/fawmodels

cost will be much less as well.

PatrickH wrote:I can also print them for you if you're in the UK?! =)
https://www.shapeways.com/shops/fawmodels

cost will be much less as well.

Thank you Sir. What would the cost be?
Cheers
Jon

Just the one piece? Can you tell me the diameter of the hole please and what brand ST is it? I'd like to make sure that it will fit. I'm at work at the moment so I'll have to wait till I get home and fired up the printer to have a look before I can give you a price.

PatrickH wrote:Just the one piece? Can you tell me the diameter of the hole please and what brand ST is it? I'd like to make sure that it will fit. I'm at work at the moment so I'll have to wait till I get home and fired up the printer to have a look before I can give you a price.

Hi Patrick.
Barrel internal diameter is 27mm but I would think the rocket would need to be 26mm to avoid an interference fit.
Cheers
Jonh

Okay i had to make new design with an outer diameter of 26mm, roughly 33mm in height and two different heads. Hollow on the inside with a slot for a barbecue stick to be inserted in for positioning in the barrel.

£6 for two excluding postage.

I confirm than design and quality are excellent with Patrick. I m very happy to buy parts with him.

You can buy closed eyes!