Page 1 of 4
In a fit of madness... KV2
Posted: Sat Jun 27, 2020 2:52 pm
by jonh
I decided to try a bit of modeling proper and decided to convert a KV2 captured turret to a Russian turret. Been done many times I know but I wanted a relatively easy project to start with. I filled in the German cupola hole with 1.5mm plasticard, did a bit of filling and sanding and this is the result. Primer arrived this morning so I got it primed. Not perfect by a long way but I hope it looks ok(ish)......
- IMG_0099.JPG (46.45 KiB) Viewed 6151 times
Re: In a fit of madness... KV2
Posted: Sat Jun 27, 2020 2:56 pm
by Jimster
Looks as if you did an excellent job. I can’t see any signs of your modification at all! That’s a skill I need to work on.
Re: In a fit of madness... KV2
Posted: Sat Jun 27, 2020 6:47 pm
by Exhibitedbrute
Looks like a Russian kv turret to me
Re: In a fit of madness... KV2
Posted: Sun Jun 28, 2020 7:14 pm
by jonh
Ah well - first mistake made. I just looked at a drawing of the turret and realized (noticed) that the right hand periscope is not in fact inline with the left hand and should be in a more rearwards position - cut it off and start again time!
- KV2 periscopes.jpg (14.51 KiB) Viewed 6061 times
Re: In a fit of madness... KV2
Posted: Sun Jun 28, 2020 8:01 pm
by midlife306
Don’t worry, we all have “Doh!” Moments lol
Sent from my iPhone using Tapatalk
Re: In a fit of madness... KV2
Posted: Mon Jun 29, 2020 4:49 am
by jonh
Don’t worry, we all have “Doh!” Moments lol
I just can't figure out how I missed noticing that (what an xyz??? I am)- ah well. At least it is an easy fix.
Re: In a fit of madness... KV2
Posted: Tue Jun 30, 2020 1:04 pm
by jonh
Ah - that's better (I hope). That will teach me to RTFN in future.....
- IMG_0105.JPG (34.65 KiB) Viewed 5960 times
Re: In a fit of madness... KV2
Posted: Wed Jul 08, 2020 8:46 am
by jonh
A bit more progress:
Have installed the electronics in the hull and turret:
- KV2 electronics.jpg (84.37 KiB) Viewed 5872 times
I wanted a power switch behind the rear door in the turret but the slip ring wiring was not of a gauge suitable to carry the required current so I installed a relay in the hull in order to greatly reduce the current through the slip ring wires.
Here is a rather boring pic of the inside of the upper deck:
- KV2 turret inside.jpg (57.99 KiB) Viewed 5872 times
Probably even more boring - a pic of the upper deck in primer:
- KV2 in primer.jpg (57.85 KiB) Viewed 5872 times
I have also adapted the standard unit recoil to use a servo recoil.
Re: In a fit of madness... KV2
Posted: Wed Jul 08, 2020 1:56 pm
by PainlessWolf
Good Morning!
Not boring to me. The KV-2 is one of my favorite tanks and you are doing a bang up job with this one. Following along.
regards,
Painless
Re: In a fit of madness... KV2
Posted: Wed Jul 08, 2020 3:11 pm
by jonh
Thank you Painless.