Page 1 of 1

HL tk6 or taigen T5v3

Posted: Fri Jun 12, 2020 12:22 pm
by Mitch45
Hi all, I resently bought a HL tiger 1 off eBay and am starting to upgrade starting with a metal hull and running gear. At some stage I'm going to want to upgrade the electronics as the electronics as it currently has a rx13 27mhz board. I've done some research and the two options I'm looking at are the taigen T5v3 and the heng long Tk6.0. Jist wondered if anyone had any advice as in pros and cons of the two systems? Main thing I can see so far is that the taigen set if slightly more expensive but does allow you to use any independent radio set with the 6ch imports on the board.

Many thanks in advance

Re: HL tk6 or taigen T5v3

Posted: Fri Jun 12, 2020 1:13 pm
by jarndice
The Taigen V3 is much more "PlugnPlay" than the Heng Long Version 5.0 which does away with the industry standard JST Plugs so an existing Tank needs a bit of rewiring but once it has been done the Electronic package is far superior to the Taigen V3.

Re: HL tk6 or taigen T5v3

Posted: Fri Jun 12, 2020 1:54 pm
by Max-U52
I recommend that you get a Clark or an IBU and not waste your time on the stock boards. But if you do insist on a stock board, it depends on your skill set. If you're good at soldering and wiring and stuff then the HL shouldn't be a problem, but if you need completely plug-and-play then you want to go with the TG.

Re: HL tk6 or taigen T5v3

Posted: Fri Jun 12, 2020 2:12 pm
by Jimster
If I could go back in time and give myself advice I would tell me, "Watch YouTube videos on the various aftermarket boards. Listen to the sounds and see how good the slow speed control is and listen to any comments the poster makes. Don't waste money and time on cheap boards. Get a good hobby grade radio".

Re: HL tk6 or taigen T5v3

Posted: Fri Jun 12, 2020 2:32 pm
by Mitch45
Thanks everyone. It sounds like of thè 2 HL is is considered better then. Solder won't be a problem I'm an electronics engineer by profession, I've researched quite a few videos on both systems but not seen much difference between them hence asking here.

Re: HL tk6 or taigen T5v3

Posted: Sat Oct 24, 2020 1:11 am
by toshik
Max-U52 wrote:I recommend that you get a Clark or an IBU and not waste your time on the stock boards. But if you do insist on a stock board, it depends on your skill set. If you're good at soldering and wiring and stuff then the HL shouldn't be a problem, but if you need completely plug-and-play then you want to go with the TG.
Who sells IBU-3 in the States?

Re: HL tk6 or taigen T5v3

Posted: Sat Oct 24, 2020 10:42 am
by tankme
I actually like the HL TK6.0 over the current Taigen offering even if I have to use the cheap HL radio. The control is much better. Personally unless you are in a tank club and battle with other tankers I wouldn't bother with expensive aftermarket boards. That being said I have a Clark TK40S board in my SU-152 that I'm testing and so far I like it a lot. I do get out to the local club and battle every so often.