Page 1 of 1
HL tx - Loose wire!
Posted: Tue Aug 04, 2009 6:17 pm
by wibblywobbly
Can anyone tell me where this loose wire goes?
It is the one that is attached to the pcb at the very bottom of the board.
Cheers
Rob G
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 7:44 pm
by Woz
It goes to the battery compartment (The bottom tab).
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 7:52 pm
by wibblywobbly
Woz wrote:
It goes to the battery compartment (The bottom tab).
I am referring to the wire on the left in my pic. I have wires attached to the battery compartment tabs, unless the bottom tab has two wires attached?
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 8:14 pm
by Woz
Mine doesnt have a wire there but if you follow the track round to the top of the PCB it has a wire going from there to the battery compartment. Yours just has a hole there.
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 8:15 pm
by Woz
Just opened another controller. The wire goes to the middle post of the On/off switch. Behind the arieal.
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 8:18 pm
by wibblywobbly
Cheers Woz, does it bridge both terminals like the one above it?
Re: HL tx - Loose wire!
Posted: Tue Aug 04, 2009 8:20 pm
by Woz
wibblywobbly wrote:
Cheers Woz, does it bridge both terminals like the one above it?
Yes