RC Tank Warfare community hobby forum

Hello
Following the purchase of a Taigen V3 type module,to replace the original RX 18,and use wiht a conventionel radio (Flishky FS6 T ) as indicated? nothing happens and moreover no help,thank king you in advance good day.
PS: no explanatory note

Hello,
No one hase the answers or already had this problem

If you understand German

https://www.youtube.com/watch?v=8jX2BIEEt98

Jofaur86 wrote:Hello,
No one hase the answers or already had this problem

Did you put the little bind plug in?

OK,thank you for the answer but that doesn't tell me why the deck doesn't power the RX? While the fan is running

Tomhugill
Yes

I do not understand ? Already watched this vidéo,they use a RX Flysky ,but a Taigen transmitter

Thank you for diagram !! I have to connect according to diagram??but my concern is that the fan turns ?and that on my receiver the led does not ligth ? up and that everything works, with servos ? Moreover i do not understand that on the vidéo?a Taigen transmitter is used so I would like to know if it works with a radio set other than Taigen ? And why my RX does not turn on

connect as in diagram put in your transmitter selection plug number 1 in diagram your rx should be power by the taigen board as it says it has a built in bec if not then i dont know