RC Tank Warfare community hobby forum

Hi whats the best way to remove moulded on tools ie on the Pz.III and Pz.IV track guards as not to damage the none slip surface , that an sound health and safty issue  . Can you buy anything o replace this finish ?

Thanks Littletankman

Hi Andy, maybe try the thread method. You can get photo-etch sheets with the non-slip surface on them, and there more accurate than the one on the tank. Aber do really good sets of them.
Cheers,
Rik

Alternately if you are happy with the moulded tools in general it is possible to undercut them carefully with a plastikard scorer or knife blade to give them an apparent gap.

Hi Guys thanks for those tips .Im not ready for it but again thanks.

Littletankman