RC Tank Warfare community hobby forum

Hi all. Well the Challenger has come a long way since I got it but I’m now very happy with where it’s at

Any plans to sort the sag at the rear?

tomhugill wrote:Any plans to sort the sag at the rear?

Hi bud......I don’t fit the screws to fit the deck to the chassis as I’m always lifting it on/off. Once screws or fitted the rear lifts up higher

tomhugill wrote:Any plans to sort the sag at the rear?

Just propped the rear up to where the screws go in.......I haven’t fitted them since I’ve owned it but gives you an idea how it sits.......I don’t want it any higher than this

Hello Mr jeman, can I ask how you created or what was used to make the ratchet straps holding the drums down ?.

Wildboar44 wrote:Hello Mr jeman, can I ask how you created or what was used to make the ratchet straps holding the drums down ?.

Hi Buddy.....no worries. Believe it or not......to make the ratchet straps I used......cable ties for the sides, the inside of a Biro for the handle and some folded plastic for the middle plates.....then just painted them.....I’m really pleased how they turned out.

jeman wrote:

Wildboar44 wrote:Hello Mr jeman, can I ask how you created or what was used to make the ratchet straps holding the drums down ?.

Hi Buddy.....no worries. Believe it or not......to make the ratchet straps I used......cable ties for the sides, the inside of a Biro for the handle and some folded plastic for the middle plates.....then just painted them.....I’m really pleased how they turned out.

WOW, so simple yet very realistic. Congratulations