RC Tank Warfare community hobby forum

Good Morning
I have a H/L Pzr III lower hull it has a Heng Long PCB RX-18 Mainboard Multi function unit. it has a circuit board but no battery or even control unit.
I'm just looking to find out what control unit this would use? a total newbie at the electronics side of everything.
thank you in advance.
regards
Sean

I assume that you have something like this then? (Stolen shamelessly from RCTA)



Are you looking for the transmitter? It will likely be one of these:

Hello,
Good evening,
It is and old radio in 27 Mhz outdated nowadays,advice replace by current système 2.4 ghz the wiring is electrical,there is just to turn the plate and existing receveir ,
The speaker and smoking, system will be kept.
https://www.rctank.de/Taigen-V2-V3-telecommande-24-GHz
https://www.rctank.de/24-GHz-platine-pr ... -et-autres

SEAN66 wrote:Good Morning
I have a H/L Pzr III lower hull it has a Heng Long PCB RX-18 Mainboard Multi function unit. it has a circuit board but no battery or even control unit.
I'm just looking to find out what control unit this would use? a total newbie at the electronics side of everything.
thank you in advance.
regards
Sean

If you are looking for a Heng Long transmitter controller (The chrome silver and black large control unit above) and matching receiver with a pair of Crystals I have several old units you can have. The crystals, one goes in your controller (the item with the number 2 sticker on sender control unit pictured) and another crystal goes in your tank underneath. If you want a break down of a working RX18 set complete I can photo and post them if you want.


When this CV-19 is out the way and we are not risking the health of our postal workers I can send them to you. Gordon.

Thank you for all the replys.
Thank you very much for your kind offer Wildboar44,
I'll PM you.
Regards
Sean