RC Tank Warfare community hobby forum

If I remember from the old days of 4ch Clark, I had a hard time with my spectrum radio and rx too. The only set that very gave me trouble. Radio worked fine with my elmod.

I think my combination on the rx was 1,3,2,4

I'm also wondering how the board can read the stick position if there is no calibration required With the ibu2 you set the boards dip switch8 position which let's you input the sticks maximum movement and similar with the ibu2u only that talks you through the stick set up, how does the clark board calculate the stick movements ?

Cheers, Lee.

Thank you Carl, I will give the plug changes a go later on, I hope I can get it working as this is my first clark board or it will be up for sale

Cheers, Lee.

Good morning, Lee,
Have you chatted up Maxmekker yet about this. He is the Clark Board guru I ask whenever one of mine does something odd.
regards,
Painless

Hi painless,

Yes maxmekker was the first person I contacted unfortunately he said he had no experience with the board and a spektrum set up so that's why I posted the question in the hope that somebody may have

Cheers, Lee.

Lee!
That is interesting. I did not realize that FlySky had such a grip on the Clark board using segment of the Hobby. You are an Adventurer, Sir, sailing in Uncharted Waters!
regards,
Painless

I don't know about sailing unchartered waters painless but if I can't get it to work it will be at the bottom of the river bed with a brick tied to it

Cheers, Lee.

Just to make sure, you have power to the board and some functions ( like turret prhaps ) ?

you could try and switch to mode 1 just for a test
that should give you the operation as seen here in my video here, that show the operate differences between the 4/6 ch and sbus setup)



see also on the tk60 page and scroll down to 6ch layout for a little help on the 'ninja' moves'
http://clark-model.com/eng/prod_rx60/index.html

Hi Stian,

Yes there is power to the board and some things work randomly, no track movement only when it decides to on it's own but they spin up extremely fast with no control and in opposite directions to each other with no input, I have not managed to get the turret traverse or elevation working at all

Cheers, Lee.

What receiver are you using? Does it support PWM servo control, or PPM?

Are you sure that the TK-24 is not an S-Bus version?