RC Tank Warfare community hobby forum

Morning all,

Couple of pictures of my last build for this year. It started out life as a 1/16 revell static kit. I modified the motor/gearbox unit and axles from heng long truck parts, it's got a micro servo for the steering and runs off a 30amp esc and 2s lipo. The space is very limited and I wanted to keep the interior as original as possible so I came up with the idea of making a roof rack which I could place a battery box up onto and disguise it as individual crates to house the battery, the esc and receiver are in the boot/trunk so the battery cable runs from there through the interior to the battery on the roof


Cheers, Lee.



Sent from my SM-G950F using Tapatalk

Excelent job!

But if you want to make it perfect You can still fit a dasmikro for giving lights and sound to the model. You can fit it everywhere! Id fit it under the rear seats, and the speaker too.

Thanks Rad, I did originally try lights on it put as it's so small the wiring was getting a bit messy so I decided against it, its only going to be a little run around so I'm happy enough with it

Cheers, Lee.

Superb job, I admire your skill.

Thank you wildboar44, appreciated sir

Cheers, Lee.

Great work, particularly in managing to keep the interior intact. Makes a world of difference.

Great work that, being able to shoehorn everything in and it still looking so good.

Model Builder 4 wrote:Thanks Rad, I did originally try lights on it put as it's so small the wiring was getting a bit messy so I decided against it, its only going to be a little run around so I'm happy enough with it

Cheers, Lee.

Oh I see... Anyway you are still my super hero. I got that kit too, and I considered to RC it but I panicked about how fragile it is, so it ended static. You have more guts than me, lol. Looks great as it is...



But fit at least lights, lol. Sorry I had to say it.

Thanks silversurfer and square4 the confined space was a big challenge, it would have been a lot easier to just put everything inside the interior but it just wouldn't look right, I was stumped for a while for a way to hide the battery and was thinking of putting it in a trailer behind but I have already done this before and was looking for a new solution for this build and that's where the roof rack idea came from

Cheers, Lee.

Thank you Rad, I'll put my superman disguise glasses on for you then .... the plastic is quite robust and forgiving, it is tricky to fit the body onto the chassis while everything is in place but it is doable and it can also be removed if work on the motor or servo needs to be undertaken. I have another of these kits still boxed so someday I may get around to doing a desert version

Cheers, Lee.