RC Tank Warfare community hobby forum

Finishing up adding metal accessory parts and had an issue.
I purchased a Mato metal driver side vision port..pretty cool..it comes in 2 pieces, the port slides, fastened by nuts..anyway I thought that the kit came with the portion of the vision block which attaches to the fore hull ..that little deflection block built into the sloped portion of the hull in front of the vision port .
I hope this part is available cause I PAINSTAKINGLY removed from the plastic hull top LOL....am I in trouble here otherwise a new top hull is in order
JEFF

Good Afternoon,
Nothing to fret about or spend time searching for a replacement. Grab a Tiger 1 info book or visit a site online and get a great look-see at the angled piece and make a new one with a couple of cuts and a few minutes worth of file work on a styrene sheet or rod. Use a gel cement to attach your hand crafted armor piece and sit back and enjoy.
Regards,
Painless