RC Tank Warfare community hobby forum

My latest project in the continuing battle with Wayne to prove who is the bigger 3D printing nut job:
The pontoons are off of Thingyverse, considerably enlarged and split into 2, because not even a CR-10S4 is big enough
I've added the loops for the ropes and replaced the original Thingyverse treadway bridge parts with my own.
I've given the first 2 a coat of Plastidip rubber spray paint - while it seems to look the part, it didn't seal the interior quite as well as I had hoped, but they still seem quite functional:

That's just amazing.

If you want to be a bigger 3D nut than Wayne you have a tough row to hoe, my friend.

Oh dear, lol. Nice work btw

Hi there!
Good job the one who is doing.
If you are not already in Thingyverse, could you upload the file so you can make a copy for the enjoyment of the forum people?
Thank you from to Spain.
Anthony.

I got the original models from here (I think?) https://www.thingiverse.com/thing:2779617

Hi Would look good as a load on the back of one of your trucks.

regards pete

Interesting you should say that, Pete. When T6 first told me about the project he showed me this photo, so I don't think he's done with this project by a long shot.

Tiger6 wrote:I got the original models from here (I think?) https://www.thingiverse.com/thing:2779617

Hi Tiger! Thanks, one question more you´r modification the pontoons in 1/100 to 1/16 yes? Because the thingiverse is in 1/100.
Thank you best regards.

Scale to 625 percent


Sent from my iPhone using Tapatalk

This ^