Re: Timbered House Type A
Posted: Sun May 26, 2019 7:09 pm
Today it goes further at the second half of my roof. At this side is the control electronic for the fan located. This pulse width modulation module came from China and was a long time on the way. But the functions are okay.
Then the first run – this is so many smokes, that I’ve to throttle the smoker a bit.
With the potentiometer at the pwm can I also throttle the fan and the smoke emission can be regulated.
The position of my control board will be later changed, so that it is accessible from the inside. In the next step have been the little chimney glued; again with Latex Bindemittel.
The boards for the laterally roof box have been also glued…
…and thereafter also the double chimney; at bottom receive both chimneys a retaining clip from wood.
Here are both retaining clips good to see.
Position of the control board was changed, followed from roof battens. Pictures…
At the chimneys have been short transitions installed, this is necessary for the roof battens.
To be continued…
Then the first run – this is so many smokes, that I’ve to throttle the smoker a bit.
With the potentiometer at the pwm can I also throttle the fan and the smoke emission can be regulated.
The position of my control board will be later changed, so that it is accessible from the inside. In the next step have been the little chimney glued; again with Latex Bindemittel.
The boards for the laterally roof box have been also glued…
…and thereafter also the double chimney; at bottom receive both chimneys a retaining clip from wood.
Here are both retaining clips good to see.
Position of the control board was changed, followed from roof battens. Pictures…
At the chimneys have been short transitions installed, this is necessary for the roof battens.
To be continued…