RC Tank Warfare community hobby forum

Complete.

It's done. I had a few issues getting Rumble to start but I can a complete fool sometimes (I didn't connect the receiver in correctly). The inside of the tank is cluttered to say the least so I wasn't able to install a new turret traverse unit. Other than that everything works like a charm.

Attaching the turret ring was a little bit of a pain since the stock turret is now gone and it's screws are no longer needed. But 10mm female hex studs and a few M3 8mm screw for both sides should do the trick. A 360 degree turret ring is highly recommended but if you're poor like me you can just cut two additional teeth into the stock ring so it can move. And there we have it.

The T-90 SM.

Sent from my Phone using Tapatalk

Very nice work. Well done. I'm glad MichaelC was able to help you sort this out with the pictures.

Sure is a small frontal area compared to the other two !!
Brilliant job Mr NoSickle , pretty complicated canvas to work with !
I wish you the very best combining it all in under paint
Congratulations being one of the first to get one of these up & running to completion

HERMAN BIX wrote:Sure is a small frontal area compared to the other two !!
Brilliant job Mr NoSickle , pretty complicated canvas to work with !
I wish you the very best combining it all in under paint
Congratulations being one of the first to get one of these up & running to completion

Thank you kind sir. Much thanks to maxmekker and DKLM for the help assembling and troubleshooting.