RC Tank Warfare community hobby forum

I am looking for the metal brake inspection hatches as shown in the picture below.
Note: they are different from the standard P-IV hatches (shorter and wider)
See the longer standard PIV hatches below showing the difference.
Can anybody tell me where to get the JP-IV version ?


Verzonden vanaf mijn iPad met Tapatalk

I’ll be watching closely as I need a set too
Cheers
Wayne


Sent from my iPhone using Tapatalk

midlife306 wrote:I’ll be watching closely as I need a set too
Cheers
Wayne


Thank you Wayne!
Sent from my iPhone using Tapatalk

Verzonden vanaf mijn iPad met Tapatalk

Can you not cut off the cowels on the top, shorten the hatches then glue the cowels back on?

I'm thinking that unless Ludwig sells them, you will have a hard job finding them.

Son of a gun-ner wrote:Can you not cut off the cowels on the top, shorten the hatches then glue the cowels back on?

I'm thinking that unless Ludwig sells them, you will have a hard job finding them.

Hi, yes I may convert the PIV hatches myself using the resin cowels of the conversion kit. The metal PIV cowels are slightly narrower than the JPIV...
Ps who is Ludwig?


Verzonden vanaf mijn iPhone met Tapatalk

www.ludwigs-hobby-seite.de
He is a master Builder of all things RC Armour and a member of this Forum.

Well, another option might be to find the appropriate Tamiya sprue for the Jagpanzer which contains the inspection hatches. Mind you that could be very expensive. I just sold the 'D' sprue for that model to a member here. That one has the front and rear panels on it, but I can't recall if it also included the hatches. You could fabricate them, of course, that would be a decent solution (make them from styrene...the hinges can be bought from Asiatam) or, as has been suggested modify existing ones.

I saw these on the Asiatam website a moment ago. They're resin, but they are for the Jagdpanzer IV, and only eleven Euros (+ post, of course..)
https://www.asiatam.de/product_info.php ... e076iqr544

43rdRecceReg wrote: Well, another option might be to find the appropriate Tamiya sprue for the Jagpanzer which contains the inspection hatches. Mind you that could be very expensive. I just sold the 'D' sprue for that model to a member here. That one has the front and rear panels on it, but I can't recall if it also included the hatches. You could fabricate them, of course, that would be a decent solution (make them from styrene...the hinges can be bought from Asiatam) or, as has been suggested modify existing ones.

Got the job done by shortening and widening the metal PIV hatches.



Filling the edges with putty





Verzonden vanaf mijn iPhone met Tapatalk

Good job jwhas, they look great

Cheers, Lee.