RC Tank Warfare community hobby forum

Hello
I'm up grading one of my tigers that has that A,B,C channel switch to a rx-13 board but i can't see where the motors attach on it.
I've looked at the rx-14 pictures but it's a diffrent layout.
can any one help.

Tackleberry 

here is a picture of the underside of an rx board from Whacky's guides,
the RX #13 and #14 use the same PCB but have different components on them and the motor wires connect to the board in the same place excepting the fact the #13's wires are soldered and the #14's are plug connections.

Thanks BREL
it was a good help and i didn't blow it this time 

Tackleberry