RC Tank Warfare community hobby forum

I know you can buy the lower hull from Tankzone but if you want to do it your self I have plans in pdf file showing how to take two lower hulls from a KT and make a JT lower hull and also shows how to make the upper hull bigger if you want them just PM me with your e-mail address and ill e-mail it to you.File is just over 1mb big.

Jimmy

just found out you can load file to so its in the first post .

Jimmy

Thanks for the download,I have been considering buying a Jagdtiger but I have my H/L Tiger hull and running gear since purchasing the asiatam lower, and with this I may try a scatch build.Thanks again.sax

I did this conversion a few years ago.
A tamiya Twin Clutch Kt to Jadgtiger
It depends how perdantic you want to get but the Chassis was lengthened for the Jadg
Most people lengthen it inbetween the rear road wheel and the idler but the chassis should also be lengthened between the Drive cog and the First Road wheel
Also when you are working out the sides don't for get that the front lower deck is slightly lower that the rear deck. You might say it doesn't matter but unless you realise there is a height difference it causes headaches latter in the build.
I drew plans for the sides and had them laser cut from 5mm Aluminium. it makes a very heavy model that unfortunately snaps tracks.