RC Tank Warfare community hobby forum

I have a non working WSN tiger 1 and i was wondering if i could fit a taigen MFU and a infrared turret onto the WSN tank?

Hi Ash,
Shouldn't be a problem, I've got HL2.4 and an asiatam/taigen recoil unit in mine. Motor connection just be ready, I had to swop wires around one one plug otherwise it was a straight swap.

cashybai wrote:Hi Ash,
Shouldn't be a problem, I've got HL2.4 and an asiatam/taigen recoil unit in mine. Motor connection just be ready, I had to swop wires around one one plug otherwise it was a straight swap.

By motor connection, you mean the connection for the drive motors? I havent opened my WSN tiger yet so i dont know how its set up inside

Yep Ash that's the one. I left the motor/gear pack in as it seemed to be working fine, just looked back through my thread viewtopic.php?f=23&t=25797 (need to update on progress) and it was polarity on one of the motors that needed swapping around barring that they plug straight into the HL. getting into the WSN is fun, you need to lift up the two rear fuel caps and the vent cap alongside the drivers hatch(all glued down) to get at the screws underneath. I magnetted the hull so I wouldn't have to faff about with that one again.

cashybai wrote:Yep Ash that's the one. I left the motor/gear pack in as it seemed to be working fine, just looked back through my thread viewtopic.php?f=23&t=25797 (need to update on progress) and it was polarity on one of the motors that needed swapping around barring that they plug straight into the HL. getting into the WSN is fun, you need to lift up the two rear fuel caps and the vent cap alongside the drivers hatch(all glued down) to get at the screws underneath. I magnetted the hull so I wouldn't have to faff about with that one again.

I've gotten around to taking one of the fuel caps off but i havent gotten the others off yet, might try after i finish installing an IR battle system on my panther