RC Tank Warfare community hobby forum

I taped everything together while gluing it all to the hull.
After a few minutes it all could be taken off.

I used a thin layer of Pattex woodglue on top of the superglue....just to be on the safe side...

h

Next I have to align the Schürzen a bit by bending some of the holders or even drill out some holes slightly larger.
Tomorrow it is supposed to become 25°C here so if there is some spare time, I will spray the Schürzen in the red anti rust primer.....the damn things are aluminum anyway...

The holders have to be cut into an appropriate length too when everything fits and is aligned the way I had in mind.
Brackets and holders will be painted in the matching camo colours on the hull too.

Just looked at my decal set.
Have no clue where it all is supposed to be on the Panther. I did expect a drawing which would have pointed out the spots where to put the decals.
I know, the numbers 003 go onto the turret
Both small Balkenkreuzen go on each side of the hull in front of the tools.
Where comes the bigger Balkenkreuz, if I will use it anyway.
One decal must be for the fire extinguisher, I think the yellow one with the text written on it.
But that green leave thing with the red N and the white panther jumping through it, where must that one go on my Panzer?
Front hull, driver's side perhaps?

h