RC Tank Warfare community hobby forum

Hi , as most of you saw I now have a cool, hand made in the Netherlands 1945 Hunting Panther.

It is amazing, however the electrics were not. They were old and dated. I started by removing the old firing unit (blanks) and all the wiring on the top portion. All that remains are the motor leads and the ground /power, the vantec speed controller has its wires also. So next I need the appropriate toggle switch, on/off on/on etc...
Any advice on that appreciated

Hopefully I will get some free time this weekend to continue.
New update and hoots soon



Sent from my iPhone using Tapatalk

I actually got it to run today !
I hooked the battery to the main power of the speed controller, then attached my receiver powered by AA batteries and it runs. Forward backwards left and right.
I could use a little wiring advice on switch selection. I have 6 wires + & - for main power to speed controller and then a + & - for each of the motors. So I assume a 6 pole toggle but whitch configuration and how do I wire it. Cheers

The 6 wires I need a toggle for



Sent from my iPhone using Tapatalk