RC Tank Warfare community hobby forum

Here's the place to submit a video of your tank, military trucks or armoured vehicles. If you submit in the photo section, don't submit here. Likewise if you post a video, don't submit the same vehicle in the photo section. Pretty simple

Videos should be anywhere from a minute to 5 minutes long. Put some information about the build on your submission.

Let's have fun

There are a few days left to enter the TOTM video submission thread. Nobody has entered yet, huge turnout for the photo section

Let's get a few pieces for this month's video competition

Hola all. To help out a Friend, I will toss up a simple video of my early StuG III Ausf B.. This was a very short outdoor run of the assault gun. Built and painted some time ago by yours truly using a Taigen Pz III, a TauchPanzer upper hull and a Profiline StuG III resin kit. Enjoy!



( This will be easy to one up so help Carl out and post up a Video! ;o)

well colleagues, this is my StuG III Ausf. F. It was my 1st RC tank, consisting of an HL StuG III Ausf. G and completely new scratch built upper hull made of Styrene. Still working with an RX-18, 27MHz.
The MG is only an idea, because in the early days, StuG´s had only MP´s for self defence. It uses a very small LED through the gun tube.



Freddy

PJ66!
Love that video and the led firing through the MG!! I have one set up on the back deck of my early StuG because I bet that those assault gun commanders were looking for and obtaining any kind of infantry defense weapons that they could. I have one of the 'crew' firing an MP-40 through the drivers vision slit. ( Seemed the best use of the mg led and some fibre optic line to me at the time but your MG on the case mate roof is a show stopper! )
regards,
Painless

Well, if we're throwing up old StuG videos this month I'll climb on board. Personally, I like both the previous entries better than mine (that LED machine gun is especially cool), but I do have the coolest Tank Commander. You'll have to look close to spot him, though.



And just fair warning - when I finally get around to doing the video of the Hetzer for this thread, the rest of you Mulletheads might as well stay at home. Nyaah.

Edit: Carl asked for a bit on the build, so

Imex/Taigen Metal Edition StuG III
Brass dual ratio gearboxes
IBU2
Metal tools
Metal Spare Track
New air filter boxes with PE screens
And of course a bucket

It can't just be stugs. Little video of my Cromwell being put through its paces on grass.

100% scratch built Comet A34. Clark TK24, and the worst cameraman in the world...