Hi, I'll try to make it simple (I'll try)Markocaster wrote:Magnificent work
How did you create the blistered paint effect.
Can’t wait to see it w the smoke
Sent from my iPad using Tapatalk
You have 3 ways to do it:
Maskol
PVA / White glue
Using diffent type of paint
For this one I used Maskol.
-1st: Primer
-2nd: Rust tones, using mapping. Rust don't have a uniform colour, I used Tamiya acrylics for this one, other brands like AK interactive, have sets with rust tones but I'm old school and I like to make my own mix of coulours. Here I used Red Hull, NATO Brown, Red Brown, Dark Brown, Red, Orange and Yellow (always use matt colours except on the areas where rust can be polished like on an old display tank). You can also put some pigments on the area where the Maskol or glue will be applied (the liquid will have less grip with the pigments underneath, also when you'll be removing the maskol the under layer will have a nice rust tone too)
For the technique where you're using different type of paint:
Simple chemistry lesson: water based products and pretrol based don't mix. Using that, first spray the rust tones using ENAMEL paint, once dry, used acrylic paint with a BRUSH. The acrylic paint won't stick to the enamel creating blisters. This is more difficult to achive.
-3rd: Maskol or PVA Glue, on the areas where I want to have the paint peeling or blistering, I'm applying Maskol or PVA glue with a brush. Don't forget to overflow a little bit on each side (the rusty area and where you will have the normal paint) and let it dry.
-4th: Paint, now with an airbrush, you can spray the colour you want on top of it. Let it dry.
-5th: creating the effect, with a toothpick or a needle, gently remove the Maskol or Glue where you want to get the blisters.
Once done, you can now play with washes, pigments etc. If you want to get the burned out effect on the paint: spay a thin layer of hairspray, once dry, a mix of flat black diluted with thinner using an air brush on the border will do the job.
Directly once the paint is dry, using a flat brush moisted with water, gently pass over the area and small chips will appears. Also don't use flat black directly but try to create also a mix of tones from dark black to dark grey. This is the result of the consumsion of the paint but also the smoke due to the various internal or satellite components (rubber from the wheels etc)
I hope this answer your question